Customer Reviews
Everything is super! For the UART mode, you need to rearrange the jampers, as written in the instructions on the githaba. Drivers are already unpacked under UART. If the TMC error comes out when you start-put another firmware, although, perhaps not to run the board without drivers for the first time, as I did) someone knows, is it possible to adjust the fan at hotend?
Thank you for the fast delivery. I haven't tested it because I haven't used it yet. The first connection was made. However, a tmc connection error occurs.
The ducky has landed. Lightning fast delivery, good packaging. Everything seems OK! This is a true drop-in, plug and play replacement. After mounting the board my Ender-3 was ready to print immediately. Even the safety features are enabled by default! And the silence is just glorious. The steppers are now quieter than a whisper. Noise levels dropped by ~10-15 dB. Only thing I disliked was the smallish, flimsy hotend wire terminal. It bent quite a bit when tightening the wires in place. The hotend fan terminal is as big as the hotbed terminal for some reason. They're also right next to each other, so don't mix them up! Other than that this is a great product. I advise everyone to purchase this board if you want a no-fuss upgrade.
It a great upgrade that I would recommend to people looking for a silent solution for their Ender 3 or Ender 3 Pro. It’s easy to install and keep in mind to take pictures of the wires before disconnecting. Check my installation video on YouTube zachary3dprints
Great fee. Fast shipping. The quality of printing has become much better. Put on Anet A8.
